3.7

Out of 43 Ratings

Owner's of the Samsung Refrigerator RF4287HARS gave it a score of 3.7 out of 5. Here's how the scores stacked up:
  • Reliability

    3.77 out of 5
  • Durability

    3.58 out of 5
  • Maintenance

    3.64 out of 5
  • Performance

    3.76 out of 5
  • Ease of Use

    3.77 out of 5
of 42
 
26_ Operating
 When you pull the water filter, a little water can leak from the opening. This is normal. To minimize the
water leaks, keep the filter cartridge horizontal when you pull it.
 To prevent overflow, empty the water tray filter ( 3 ) and dry around of
case filter ( 2 ).
 Insert the new filter into the filter case ( 4 )
 Push the filter, and then turn it clockwise until it locks.
 If you are in trouble of inserting the water filter as high pressure of water, shut off the water supply
valve.
 The locked symbol should be lined up with the indicator line.
 press the "" button (
(Filter Reset)
) for about 3 seconds
to reset the water filter. The color of indicator (
) changes from red to blue, green,
or yellow.
 If you turned off the water supply, turn it back on.
For a replacement water filter, you can visit your local home Improvement center or contact the Samsung
Parts distributor.
Be sure the replacement water filter has the SAMSUNG logo on the box and on the water filter.
Link : http://www.samsungparts.com

 Turn ON the main water supply and supply water from water supply line.
 Run water through the dispenser until the water runs clear (approx. 6 to 7 minutes).
This will clean the water supply system and remove air from the lines.
 Additional flushing may be required in some households.
 Open the Refrigerator door and make sure there are no water leaks coming from the
water filter.
Be sure to flush the dispenser thoroughly, otherwise water may drip from the dispenser.
This means that there is still air in the line.

 : The pressure of the water supply coming out of a reverse osmosis system going to the water
inlet valve of the refrigerator needs to be between 35 and 120 psi (241 and 827 kPa).
If a reverse osmosis water filtration system is connected to your cold water supply, the water pressure to the
reverse osmosis system needs to be a minimum of 40 to 60 psi (276 to 414 kPa.)
If the water pressure to the reverse osmosis system is less than 40 to 60 psi (276 to 414 kPa):
 Check to see whether the sediment filter in the reverse osmosis system is blocked. Replace the filter if
necessary.
 Allow the storage tank on the reverse osmosis system to refill after heavy usage.
 If your refrigerator has a water filter, it may further reduce the water pressure when used in conjunction
with a reverse osmosis system. Remove the water filter.
If you have questions about your water pressure, call a licensed, qualified plumber.
4
3
2
DA68-01922B.indb 26 2010.4.24 10:53:39 AM