0
Owner's of the Bose Portable Speaker Bose Outside Loudspeaker gave it a score of 0 out of 5. Here's how the scores stacked up:
9
Installing Your 251
TM
Speakers
Figures 13A and 13B
Temporarily tighten the
speakers to the brackets
A. Exterior of the house
B. Deck railing or table
Making the connections
Preparing the speaker wire (not provided)
Speaker cord consists of two insulated wires. The insulation around one wire is striped,
collared, or ribbed. This marked wire is positive (+). The plain wire is negative (–). These
correspond to the red (+) and black (–) terminals on the back of the speaker, receiver, or
amplifier. Be sure to connect each wire to the proper terminal (positive to positive, negative
to negative).
Figure 14
Preparing the ends of each
wire
At the ends of each cord, strip approximately
1
⁄
2
inch (1.3 cm) of insulation from both wires
(Figure 14). Next, twist the ends of each wire so there are no loose strands.
A.
B.
1
⁄
2
inch (1.3 cm)
Attaching the speakers to the brackets (cont.)
Figures 15
Unscrewing the hex knob
Connecting the speaker wire to the speakers
At the back of your speaker, unscrew the hex knobs on the terminal posts. This reveals a
small opening through each post (Figure 15). Using the wire guides, insert the marked wire
into the red (+) terminal. Then insert the plain wire into the black (–) terminal. Tighten the
knobs to secure the wires. See Figures 16A and 16B on page 10.
Find Your Products By Category
Please Login
