0
Owner's of the Lasko Electric Heater 102 gave it a score of 0 out of 5. Here's how the scores stacked up:
®
Rev. B 4/11
2
100ES
Rev. B 4/11
7 100ES
SERIE 100
CONSEJOS PARA IDENTIFICAR PROBLEMAS
Si su calefactor se apaga inesperadamente o no funciona, es
probable que la función de seguridad descrita anteriormente
se haya activado para impedir el sobrecalentamiento.
1. Cerciórese de que el cable eléctrico esté enchufado en un
tomacorriente en buen estado.
2. Si su Calefactor opera durante varios minutos y se apaga
repetidamente, es posible que el mismo requiera limpieza.
Ver la sección de Mantenimiento abajo.
Si tiene algún problema que no pueda resolverse con los
pasos indicados más arriba, contacte a Asistencia Técnica al
1-800-233-0268, de lunes a viernes, entre las 8am y las 5pm
(Horario Estándar del Este de los Estados Unidos).
FUNCIONAMIENTO (Figura 1)
1. Retire cuidadosamente el Calefactor de su bolsa y caja.
ADVERTENCIA: Las etiquetas de plástico o caucho, quieren
los pies en esta unidad, pueden atascar a superficies de
muebles. La unidad puede salir un residuo que podría
oscurecer, poder manchar o podría salir imperfecciones
permanentes en el fin de ciertas superficies de muebles,
inclusive superficies de madera.
2. Coloque el Calefactor sobre una superficie firme y
plana.
3. Cerciórese de que la Perilla de Encendido del Calefactor
esté en la posición de APAGADO antes de enchufarlo a
un tomacorriente.
4. Conecte el cable a un tomacorriente de 120 voltios.
Asegúrese que el enchufe encaje firmemente
en el tomacorriente.
Cuando los enchufes quedan flojos dentro de
los tomacorrientes, podrían deslizarse parcial
o completamente fuera del tomacorriente
con el menor movimiento del cable adosado.
Los tomacorrientes en este estado podrían
sobrecalentarse y representar un peligro de
incendio grave; si queda cubierto por una cortina
o tela, el peligro de incendio es todavía mayor.
5. Para encender el Calefactor presione el boton de
encendido en la posicion de encendido (I). La luz roja se
mantendra prendida mientras el Calefactor este encendido.
(Figura 1)
6. Para apagar el Calefactor presione el boton de encendido
en la posicion de apagada (O). La luz roja se apagara y
desconecte el Calefactor del enchufe. (Figura 1)
FUNCIÓN DE SEGURIDAD
1. Se incorpora un protector para sobrecargas térmicas a fin
de impedir el sobrecalentamiento.
2. Si se alcanza una temperatura de sobrecalentamiento, el
Calefactor se apaga automáticamente. Sólo podrá reanudar
su funcionamiento una vez que se reinicie la unidad.
Para Reiniciar el Calefactor:
1. Desenchufe el Calefactor y espere 10 minutos para que
la unidad se enfríe.
2. Después de 10 minutos, enchufe el Calefactor nuevamente
y siga la INSTRUCCIÓN DE FUNCIONAMIENTO que se
describe en este manual de instrucciones.
Figura 1
1. ALWAYS PLUG HEATERS DIRECTLY INTO A WALL OUTLET/RECEPTACLE. NEVER USE WITH AN EXTENSION CORD. DO NOT
PLUG HEATER INTO ANY OTHER CORD CONNECTED DEVICE, SUCH AS A POWER STRIP, SURGE PROTECTOR, MULTIPLE
OUTLET ADAPTER, CORD REEL OR OUTLET-TYPE AIR FRESHENER. THE USE OF SUCH DEVICES MAY CREATE A FIRE HAZ-
ARD. PLUG UNIT DIRECTLY INTO A 120V WALL OUTLET ONLY.
WARNING: FAULTY WALL OUTLET CONNECTIONS MAY CAUSE THE WALL OUTLET TO OVERHEAT. BE SURE THAT HEATER PLUG
FITS TIGHTLY INTO OUTLET BEFORE EACH USE. DURING USE, CHECK TO MAKE CERTAIN THE HEATER PLUG IS NOT OVER-
HEATING. IF NECESSARY HAVE A QUALIFIED ELECTRICIAN CHECK AND/OR REPLACE THE WALL OUTLET.
2. Use this Heater only as described in this manual. Any other use not recommended by the manufacturer may cause fire, electrical
shock, or injury to persons.
3. Make certain that the room is equipped with a working smoke detector.
4. Make certain that the power source conforms to the electrical requirements of the Heater.
5. Extreme caution is necessary when any Heater is used by or near children or invalids and whenever the Heater is left
operating unattended.
6. This appliance has a polarized plug (one blade is wider than the other). To reduce the risk of electric shock, this plug is intended to
fit in a polarized outlet only one way. If the plug does not fit fully in the outlet, reverse the plug. If it still does not fit, contact a
qualified electrician. Do not attempt to defeat this safety feature.
7. Do not operate any Heater with a damaged cord or plug or after the Heater malfunctions, or has been dropped or damaged in any man-
ner. There are no user serviceable parts. Please contact Customer Service at 800-233-0268 Monday through Friday from 8am to
5pm EST for assistance.
8. To disconnect Heater, turn the Heater OFF then remove the plug from the outlet.
9. Always unplug Heater when not in use. Unplug power cord before servicing or moving the Heater.
10. Do not insert or allow fingers or foreign objects to enter any ventilation or exhaust opening as it may cause an electric shock, fire,
or damage the Heater. Do not block or tamper with the Heater in any manner while it is in operation.
11. To prevent a possible fire, do not block air intakes or exhaust in any manner. Do not place on soft surfaces, like a bed, where open-
ings may become blocked.
12. Always place the Heater on a stable, flat, level surface when operating, to avoid the chance of the Heater overturning. Locate the
Power Cord so the Heater or other objects are not resting on it. DO NOT run Power Cord under carpeting. DO NOT cover Power
Cord with throw rugs, runners, or similar coverings. Arrange Power Cord away from room traffic and where it will not be tripped over.
13. This Heater is HOT when in use. To avoid burns, do not let bare skin touch hot surfaces. Always use handle when moving this Heater.
Keep combustible materials, such as furniture, pillows, bedding, papers, clothes and curtains at least 3 feet (0.9 m) from the front
of the Heater and keep them at least 1 foot (0.3 m) from the sides and rear.
14. A Heater has hot and arcing or sparking parts inside. DO NOT use the Heater in areas where gasoline, paint, or flammable liquids
are used or stored. DO NOT use Heater in locations where flammable or explosive chemicals are stored, or in wet atmospheres. This
Heater is intended for general use ONLY.
15. This Heater is not intended for use in wet or damp locations. This Heater is not intended for use in bathrooms, laundry areas and
similar indoor locations. NEVER locate a Heater where it may fall into a bathtub or other water container.
16. DO NOT use Heater outdoors.
17. This Heater is not suitable for use in agricultural facilities including areas where livestock, poultry or other animals are confined. Please
refer to National Electric Code (NEC) Article 547-7 (2008), or applicable state or local codes or standards relating to electrical
requirements for Agricultural Buildings. THIS HEATER DOES NOT MEET THE REQUIREMENTS OF NEC ARTICLE 547-7 (2008).
18. This Heater is not suitable for use in hazardous locations. Please refer to National Electric Code (NEC) Article 500 or applicable state
or local codes or standards relating to electrical requirements for Hazardous locations. THIS HEATER DOES NOT MEET
THE REQUIREMENTS OF NEC ARTICLE 500 (2008).
WARNING: REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK – DO NOT USE THIS HEATER WITH ANY SOLID STATE SPEED
CONTROL DEVICES.
IMPORTANT SAFETY INSTRUCTIONS
When using electrical appliances, basic precautions should always be followed to reduce the risk
of fire, electrical shock and injury to persons, including the following:
Read all instructions before using this Heater.
DO NOT DEPEND ON THE ON/OFF SWITCH AS THE SOLE MEANS OF DISCONNECTING POWER WHEN
SERVICING OR MOVING THE HEATER. ALWAYS UNPLUG THE POWER CORD. ALWAYS TURN OFF AND
UNPLUG HEATER BEFORE LEAVING THE AREA. NEVER LEAVE CHILDREN UNATTENDED WHEN THE
HEATER IS ON OR PLUGGED IN.
SAVE THESE INSTRUCTIONS
En la posicion de
encendido
En la posicion de
apagado
El boton de
Encendido
Find Your Products By Category
Please Login
