Sherwood Stereo System RX-4105 User Manual

4.3

Out of 3 Ratings

Owner's of the Sherwood Stereo System RX-4105 gave it a score of 4.3 out of 5. Here's how the scores stacked up:

  • Reliability

    5.0 out of 5

  • Durability

    4.67 out of 5

  • Maintenance

    4.33 out of 5

  • Performance

    5.0 out of 5

  • Ease of Use

    2.33 out of 5
of 18
 
11
“TON DIR” is displayed and the sound that
bypasses the tone circuitry will be heard.
To cancel the tone direct function, press this
button again to display “TON CTRL”.
To listen to a program source without the tone
effect.
10
Each time this button is pressed, the
corresponding tone mode is selected and
shown for 3 seconds as follows:
Enter the tone mode.
8
If the tone display disappears, start from the
step 8 again.
Notes:
Extreme settings at high volume may damage
your speakers.
In general, the bass and treble levels are
adjusted to 0.
At the desired tone mode, adjust the
tone as desired.
9
Adjusting the tone(bass and treble)
“BAL” and the balance level is displayed for 3
seconds.
Enter the balance mode.
11
If the balance display disappears, start from
the step 11 again.
Note:
In general, the balance level is set to 0.
Adjust the sound volume balance
between the left and right speakers.
12
Adjusting the sound volume balance
Note:
When the tone direct function is activated, the
tone mode cannot be entered and “TON DIR”
flickers for 3 seconds.

   Find Your Products By Category